Vinyl siding installation is a huge investment on your property. This is why you need only the best siding contractor in Downriver Michigan, for a professional installation. There are common mistakes made by unprofessional siding installers, which you have to avoid. If not, you may end up ruining your expensive vinyl installation. We encourage homeowners to refrain from embarking on vinyl siding installation alone. Many errors could be made, and damage could be done to the materials you bought with your hard-earned cash.

Why You Need to Get the Best Siding Contractor in Downriver Michigan 

You should rethink if you plan to handle your siding installation yourself without the help of the best siding contractor in Downriver Michigan. Here are some of the mistakes to avoid during siding installation. 

1. Excess Overlap in Panels

Professionally the industry standard permits an overlap of 1 inch to 1,25 inches where two panels are joined. However, the movement gets restricted when the overlap gets too much. This alone could lead to canning. Canning is an obvious weariness in the flat parts of metal wall panels and metal roofing. This is technically referred to as stress wrinkling or oil canning.

2. Making Obvious Seams

If your siding needs to be properly installed, the vinyl siding can make the house look like a project gone wrong. This condition is more of an eyesore than a functional glitch. Panels should be laid so they start and end evenly up to the wall. Staggering them in a zipper style can cause much attention to the straight seam. When this happens, it results in a series of long lines running around the house. Hiring the best siding contractor in Downriver Michigan, will save you from a lot of stress and error.

3. Nailing Too Tight on the Vinyl Siding

It is important to leave space for vinyl siding to move. This is most important in historic or wooden homes. Nailing vinyl siding too tight can lead to wet or rotten wood underneath. Instead of driving the nail too tight, professional siding installers nail it loosely. It is better to leave 1/32 of an inch between the vinyl and the fastener head so there can be space for the siding to move.

4. Allowing Too Much Room Between Fasteners

Of course, no homeowner wants a home with wavy siding. For this reason, leaving too much space between fasteners is a fatal mistake. Allowing fasteners to stay far apart allows wind to cause waviness in the material, which is not a good sight.

5. Cutting Corners on Flashing

At a place where the roof of a one-story garage joins with the vinyl-clad wall of a two-story building, there arises a requirement for metal flashing. Flashing is made from aluminum and is used to divert water that runs off the rooftop. Water is supposed to run down the exterior of the vinyl and not inside of it. If it runs inside, it may soak the sheathing if immediate action is not taken.

Conclusion

In conclusion, metal flashing is required to keep water from entering the intersections of the windows and walls. Also, to prevent water from penetrating the vinyl brick or cladding that covers a section of the same building. The best siding contractor in Downriver Michigan ensures that the transition from brick to vinyl is well concealed with aluminum head flashing. This is installed beneath the vinyl and over the brick for at least 4 inches at where they are joined.